Добрый день
Вопрос такой - имеется кошка 3660 + 2 modema tainet 336 + кошка 17xx
Решил тут своих ребят по кошкам поднатоскать думаю соберу стенд учебный
модем 1 мовесил на Serial 2/0 Cisco3660, второй модем повесил на Serial 0/0 Cisco17xx соеденил 2 модема по физике(кабель нормальный проверенный)
по 2 проводке
Сконфигурил кошки как надо но кошки енти мопеды успешно увидели
На одном модеме загрузил 3 profile на 2 модеме загрузил 4profile
все вроде мопеды снюхались и счастливо написпли Connect)))
Вопрос я не могу пропинговать не один из интервейсов кошки пробовал
в чем дело ума не приложу вродеже все выставил
Спасибо за ответ
sh int s2/0, sh int s0/0
sh run int s2/0, sh run int s0/0
sh access-list
???
router3660#sh int s2/0
Serial2/0 is down, line protocol is down
Hardware is M4T
Description: cic36
Internet address is 192.168.2.1/24
MTU 1500 bytes, BW 2000 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation PPP, crc 16, loopback not set
Keepalive set (10 sec)
LCP Closed
Closed: IPCP, CDPCP
Last input never, output never, output hang never
Last clearing of "show interface" counters 00:00:40
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions DCD=up DSR=up DTR=up RTS=up CTS=up---------------------------------------------------------------------------
cisco1700#sh int s0/0
Serial0/0 is administratively down, line protocol is down
Hardware is PowerQUICC Serial
Description: 288
Internet address is 192.168.2.2/24
MTU 1500 bytes, BW 2000000 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation PPP, LCP Closed, loopback not set
Last input never, output never, output hang never
Last clearing of "show interface" counters 00:06:03
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/1000/64/0 (size/max total/threshold/drops)
Conversations 0/0/256 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
Available Bandwidth 1500000 kilobits/sec
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
DCD=up DSR=up DTR=up RTS=up CTS=up-------------------------------------------------------------------
router3660#sh run int s 2/0
Building configuration...Current configuration : 134 bytes
!
interface Serial2/0
description cic36
bandwidth 2000
ip address 192.168.2.1 255.255.255.0
encapsulation ppp
no fair-queue
end
---------------------------------------------------------------------
cisco1700#sh run int s 0/0
Building configuration...Current configuration : 181 bytes
!
interface Serial0/0
description 288
bandwidth 2000000
ip address 192.168.2.2 255.255.255.0
encapsulation ppp
no ip route-cache
no ip mroute-cache
fair-queue
end
---------------------------------------------------------------------
router3660#sh access-listrouter3660#
---------------------------------------------------------------------
cisco1700#sh access-listcisco1700#
>cisco1700#sh int s0/0
>Serial0/0 is administratively down, line protocol is downвыключен, сказать порту no shutdown
Я уже енто делал, я просто его отрубил понимаешь он даже кольцо не пингует
типа ping 192.168.2.2 или пинг 192.168.2.1
Fast пингуется а ента шняга нет
>Я уже енто делал, я просто его отрубил понимаешь он даже кольцо
>не пингует
>типа ping 192.168.2.2 или пинг 192.168.2.1
>Fast пингуется а ента шняга нетСейчас линии в UP а протокол дергается up/down ? Или и line down ?
А вообще с ppp не так все просто, пробуйте сначала encap slip ,
там хоть авторизация не нужна...
У моих кошек нету encap slip
Serial2/0 is up, line protocol is down
почему после no sh line protocol is down и как енто включить?
>Serial2/0 is up, line protocol is down
>почему после no sh line protocol is down и как енто включить?Да да 1700 у вас выключен интерфейс...
cisco1700#sh int s0/0
Serial0/0 is administratively down, line protocol is down
>У моих кошек нету encap slipНу а какие есть ? hdlc ? и line is UP или таки нет ?
Ne muchaysya. Uberi encapsulation ppp. A luchshe sdelay def int s0/0, def int s0/1 i zanovo propishi IP adresa. Ya dumayu, chto vsio dolzhno budet podniat'sya.
>Ne muchaysya. Uberi encapsulation ppp. A luchshe sdelay def int s0/0, def
>int s0/1 i zanovo propishi IP adresa. Ya dumayu, chto vsio
>dolzhno budet podniat'sya.Пусть ребята натаскиваются, следующая натаска будет по протоколу ppp
и aaa :-) А вообше на serial по умолчанию вроде encap hdlc
збросил инты в деф но не чего не изменилась
encap поставил hdlc
line так же осталось в down
>збросил инты в деф но не чего не изменилась
>encap поставил hdlc
>line так же осталось в downНа 1700
conf t
int se0/0
no shut
no encap ppp
encap hdlc
exit
wr
Togda vistavlyaem porti v default i stavim fizicheskiy zavorot za modemom. Smotrim, sh int s0/0, poyavilas' li loopback na interface?
>>збросил инты в деф но не чего не изменилась
>>encap поставил hdlc
>>line так же осталось в down
>
> На 1700
> conf t
> int se0/0
> no shut
> no encap ppp
> encap hdlc
> exit
> wr
>
>clock rate xxx
>clock rate xxxот кабеля зависит, DTE(не поможет) или DCE и вообще, как подключено,
syns или asyn ? тогда смотреть на phys-layer
Claster! проблему решил, если да напиши как, таже проблема встала...