Памагите пзаласта! mpd выдаёт ошибку авторизации хотя в конфиге это присутствует:

****
[vpn] LCP: rec'd Ident #0 link 0 (Opened)
MESG: user-ppp 3.1 (built Oct 15 2004)
[vpn] CHAP: rec'd CHALLENGE #1
Name: ""
Using authname "user"
[vpn] CHAP: sending RESPONSE
[vpn] CHAP: rec'd RESPONSE #1
Name: ""
Peer name: ""
mpd: empty auth name
Can't get credentials for ""
[vpn] CHAP: sending FAILURE
[vpn] LCP: authorization failed
[vpn] device: CLOSE event in state UP
pptp0-0: clearing call
[vpn] device is now in state CLOSING
[vpn] device: DOWN event in state CLOSING
[vpn] device is now in state DOWN
[vpn] link: DOWN event
[vpn] LCP: Down event
[vpn] LCP: state change Opened --> Starting
[vpn] LCP: phase shift AUTHENTICATE --> DEAD
******

mpd.conf:
vpn:
    new -i ng1 vpn vpn
    set iface disable on-demand
    set iface addrs 192.168.1.1 192.168.2.1
    set iface idle 0
# disconnect the client after 8 hours
    set iface session 28800
    set iface route default
    set bundle disable multilink
    set bundle authname "user"
    set bundle password "пароль"
    set link yes acfcomp protocomp
    set link no pap
    set link yes chap
    set link mtu 1460
# If remote machine is NT you need this..
#    set link enable no-orig-auth
#    set link keep-alive 10 75
#    set ipcp yes vjcomp
#    set ipcp ranges 192.168.1.1/32 192.168.2.1/32
#    set ipcp ranges 192.168.0.5/32 192.168.0.1/32
#
# The five lines below enable Microsoft Point-to-Point encryption
# (MPPE) using the ng_mppc(8) netgraph node type.
#
    set bundle enable compression
    set ccp yes mppc
    set ccp yes mpp-e40
    set ccp yes mpp-e128
    set bundle enable crypt-reqd
    set ccp yes mpp-stateless
    open

mpd.links:
vpn:
        set link type pptp
        set pptp self 10.4.1.254
        set pptp peer 10.4.100.1
        set pptp enable originate incoming outcall

• mpd vpn-клиент на freeBSD 5.3,denn, 15:48 , 02-Мрт-05

есть ли отступы перед параметрами
попробуй без кавычек