The OpenNET Project / Index page

[ новости /+++ | форум | теги | ]

Поиск:  Каталог документации

5. Format the new disk

Use the following command to format Linux partitions using ext2fs on the new disk:
mkfs.ext2 /dev/hdb1

To check the disk for bad blocks (physical defects), add the -c option just before /dev/hdb1.

If the new disk will have more than one Linux partition, format the other partitions with mkfs.ext2 /dev/hdb2, mkfs.ext2 /dev/hdb3, and so on. Add the -c option if desired.

Note: With older distributions, the command mkfs -t ext2 -c /dev/hdb1 didn't check for bad blocks under any of Red Hat, Debian or Slackware, contrary to what the man page stated. This has now been fixed.

To format a swap partition, use this command:
mkswap /dev/hdb1

Again, you can add the -c option before /dev/hdb1 to check for bad blocks.




Партнёры:
PostgresPro
Inferno Solutions
Hosting by Hoster.ru
Хостинг:

Закладки на сайте
Проследить за страницей
Created 1996-2024 by Maxim Chirkov
Добавить, Поддержать, Вебмастеру