The OpenNET Project / Index page

[ новости /+++ | форум | теги | ]

Интерактивная система просмотра системных руководств (man-ов)

 ТемаНаборКатегория 
 
 [Cписок руководств | Печать]

if_xe (4)
  • >> if_xe (4) ( FreeBSD man: Специальные файлы /dev/* )

  • BSD mandoc
     

    NAME

    
    
    xe
    
     - Xircom PCMCIA Ethernet device driver
    
     
    

    SYNOPSIS

    To compile this driver into the kernel, place the following line in your kernel configuration file:
    device xe

    Alternatively, to load the driver as a module at boot time, place the following line in loader.conf5:

    if_xe_load="YES"
    
     

    DESCRIPTION

    The driver supports PCMCIA Ethernet adapters based on Xircom CE2- and CE3-class hardware. This includes devices made by Xircom along with various OEM manufacturers.

    Please note that the driver only supports PCMCIA cards and their Ethernet functions. does not support the on-board modem device located on some version of the Ethernet/modem combo cards. In particular, Xircom RealPort2 cards are not supported by this driver.

    The driver supports the following media types:

    autoselect
    Enable autoselection of media type and options.
    10Base2/BNC
    Select 10Mbps operation on a BNC coaxial connector.
    10BaseT/UTP
    Select 10Mbps operation on a RJ-45 connector.
    100BaseTX
    Select 100Mbps operation.

    Note that 100BaseTX operation is not available on CE2-class cards, while the 10Base2/BNC mode is only available on CE2-class cards. Full-duplex operation is currently not supported. For more information on configuring network interface devices, see ifconfig(8).  

    HARDWARE

    The driver supports the following cards:

    Other similar devices using the same hardware may also be supported.  

    DIAGNOSTICS

    "xe%d: Cannot allocate ioport"
    "xe%d: Cannot allocate irq"
    A fatal initialization error occurred while attempting to allocate system resources for the card.
    "xe%d: Unable to fix your %s combo card"
    A fatal initialization error occurred while attempting to attach an Ethernet/modem combo card.
    "xe%d: watchdog timeout: resetting card"
    The card failed to generate an interrupt acknowledging a transmitted packet. May indicate a PCMCIA configuration problem.
    "xe%d: no carrier"
    The card has lost all contact with the network; this usually indicates a cable problem.

     

    SEE ALSO

    pccard(4), ifconfig(8)  

    HISTORY

    The driver first appeared in Fx 3.3 .  

    AUTHORS

    An -nosplit The device driver was written by An Scott Mitchell Aq [email protected] . This manual page was written by An Scott Mitchell Aq [email protected] , and An Tom Rhodes Aq [email protected] .  

    BUGS

    Supported devices will fail to attach on some machines using the NEWCARD PC Card framework.

    Automatic media selection is usually unreliable.


     

    Index

    NAME
    SYNOPSIS
    DESCRIPTION
    HARDWARE
    DIAGNOSTICS
    SEE ALSO
    HISTORY
    AUTHORS
    BUGS


    Поиск по тексту MAN-ов: 




    Партнёры:
    PostgresPro
    Inferno Solutions
    Hosting by Hoster.ru
    Хостинг:

    Закладки на сайте
    Проследить за страницей
    Created 1996-2024 by Maxim Chirkov
    Добавить, Поддержать, Вебмастеру