The OpenNET Project / Index page

[ новости /+++ | форум | теги | ]

Интерактивная система просмотра системных руководств (man-ов)

 ТемаНаборКатегория 
 
 [Cписок руководств | Печать]

sweep (1)
  • >> sweep (1) ( Solaris man: Команды и прикладные программы пользовательского уровня )
  • sweep (3) ( Solaris man: Библиотечные вызовы )
  • 
    NAME
         sweep - Geomview external module for  creating  surfaces  of
         extrusion and rotation.
    
    SYNOPSIS
         sweep
    
    DESCRIPTION
         Sweep is a	tool used to make surfaces of extrusion	and rota-
         tion out of geomview vect objects.	 Sweep is intended to run
         as	a geomview external module.  It	uses the  target  object,
         which must	be a vect, to create the surfaces.  To create the
         surface, press the	button marked "Make Sweep" at the  bottom
         of	 the  panel.   The  program  will  create the surface and
         automatically send	it to geomview	as  a  new  object  named
         "sweep."
    
         The two buttons at	the top	of the sweep  panel  control  the
         type  of  sweep.  If the button marked "Translational Sweep"
         is	pressed, the target object will	be used	to make	a surface
         of	 extrusion.   The  fields  marked  "Length  of sweep" and
         "Direction	of sweep" are used to control the  attributes  of
         the surface.
    
         If	the button at the top of  the  panel  marked  "Rotational
         Sweep" is pressed,	the surface formed will	be the surface of
         the rotation of the vect.	The box	 in  the  middle  of  the
         panel will	be replaced by a box with controls for the attri-
         butes of the surface of rotation.	Note that the  sweep  may
         be	 of  an	arbitrary length around	an arbitrary vector.  The
         field marked "Arc length" controls	the length of  the  sweep
         in	 degrees or radians.  The fields marked	"End of	axis" and
         "Direction	axis" are used to specify the axis  around  which
         the  vect	will be	rotated.  The field marked "Divisions" is
         used to specify the number	of pieces into	which  the  sweep
         will  be  radially	 divided.   A  higher  number will give	a
         smoother appearance.
    
    SEE ALSO
         sweep(3)
    
    AUTHOR
         Celeste Fowler	      email:  [email protected]
         The Geometry Center      phone:  (612) 626-8304
         1300 South	Second Street
         Minneapolis, MN  55454
    
    
    
    


    Поиск по тексту MAN-ов: 




    Партнёры:
    PostgresPro
    Inferno Solutions
    Hosting by Hoster.ru
    Хостинг:

    Закладки на сайте
    Проследить за страницей
    Created 1996-2024 by Maxim Chirkov
    Добавить, Поддержать, Вебмастеру