The OpenNET Project / Index page

[ новости /+++ | форум | теги | ]

Интерактивная система просмотра системных руководств (man-ов)

 ТемаНаборКатегория 
 
 [Cписок руководств | Печать]

tc574_cs (4)
  • >> tc574_cs (4) ( Linux man: Специальные файлы /dev/* )
  •  

    NAME

    3c574_cs - 3Com 3c574 Etherlink XL 10/100 PC Card device driver
    

     

    SYNOPSIS

    insmod 3c574_cs.o [pc_debug=n] [if_port=n] [irq_list=i,j,...] [full_duplex=n] [auto_polarity=n] [max_interrupt_work=n]

     

    DESCRIPTION

    3c574_cs is the low-level Card Services driver for the 3Com 3c574 EtherLink XL PCMCIA ethernet adapter. When this driver is attached to a card, it allocates the next available ethernet device (eth0..eth#). This device name will be reported in the kernel log file, and passed on to cardmgr(8).

    The driver uses the N-Way autonegotiating transceiver to negotiate the speed and duplex of the network link. If the link partner does not support negotiation, only the link speed is detected.

     

    PARAMETERS

    pc_debug=n
    Selects the PCMCIA debugging level. This parameter is only available if the module is compiled with debugging enabled. A non-zero value enables debugging.
    if_port=n
    Selects the transceiver type. Only 0, 1, and 4 are acceptable values, other values return an error. This actual value specificed is ignored -- the autonegotiating transceiver selects the media speed and duplex used.
    irq_list=i,j,...
    This option limits the set of interrupts that may be allocated by this driver. The default is all normally-usable IRQs.
    full_duplex=n
    This flag determines if only full-duplex modes are advertised. It defaults to 0 (false).
    This flag can be used to control the transceiver's auto polarity
    detection capability. Some Cisco Catalyst switches are known to interact badly with this feature in 10baseT mode. It defaults to 1 (enabled).
    max_interrupt_work=work-limit
    This option selects the maximum amount of work handled during each interrupt. Each received packet counts as one unit of work, as does updating statistics counters and handling errors. The default is 32.

     

    DIAGNOSTICS

    eth#: interrupt(s) dropped!
    Indicates that the driver did not receive an interrupt notification for some reason. The driver will poll the card (with a significant performance penalty) if the problem persists. The most likely cause is an interrupt conflict and/or host bridge configuration problem.

     

    AUTHOR

    Driver core: Donald Becker - [email protected]

    PC Card interface: David Hinds - [email protected]

     

    SEE ALSO

    cardmgr(8), pcmcia(5), ifport(8).


     

    Index

    NAME
    SYNOPSIS
    DESCRIPTION
    PARAMETERS
    DIAGNOSTICS
    AUTHOR
    SEE ALSO


    Поиск по тексту MAN-ов: 




    Партнёры:
    PostgresPro
    Inferno Solutions
    Hosting by Hoster.ru
    Хостинг:

    Закладки на сайте
    Проследить за страницей
    Created 1996-2024 by Maxim Chirkov
    Добавить, Поддержать, Вебмастеру