The OpenNET Project / Index page

[ новости /+++ | форум | теги | ]

Интерактивная система просмотра системных руководств (man-ов)

 ТемаНаборКатегория 
 
 [Cписок руководств | Печать]

tc575_cb (4)
  • >> tc575_cb (4) ( Linux man: Специальные файлы /dev/* )
  •  

    NAME

    3c575_cb - 3Com 3c575 Etherlink XL 10/100 CardBus device driver
    

     

    SYNOPSIS

    insmod 3c575_cb.o [debug=n] [rx_copybreak=n] [max_interrupt_work=n] [use_hw_csums=n] [down_poll_rate=n] [auto_polarity=n]

     

    DESCRIPTION

    3c575_cb is the low-level Card Services driver for the 3Com 3c575 EtherLink XL CardBus series ethernet adapters. When this driver is attached to a card, it allocates the next available ethernet device (eth0..eth#). This information for this card will be reported in the kernel log file, and the device name passed on to cardmgr(8).

    The driver uses the N-Way autonegotiating transceiver to negotiate the speed and duplex of the network link. If the link partner does not support negotiation only the link speed is detected.

    If the on-card EEPROM is programmed for a full-duplex (FD) link, only FD media types are advertised and the link is assumed to be full-duplex.

     

    PARAMETERS

    rx_copybreak=n
    Set the breakpoint for copying incoming frames into reduced-sized packet buffers. The default value of 200 bytes is reasonable for most systems.
    max_interrupt_work=n
    This option selects the maximum amount of work handled during each interrupt. Each received packet counts as one unit of work, as does updating statistics counters and handling errors. The default value of 32 should only need to be increased on very slow machines. An occasional "too much work in interrupt" message is not a problem.
    use_hw_csums=n
    Controls use of an adapter's on-board TCP/IP checksum verification for incoming packets. This is on by default; setting to 0 disables hardware checksums. It may be useful to disable hardware checksums if it is suspected that something is corrupting data on its way from the card to the CPU.
    down_poll_rate=n
    For Cyclone and Tornado chipsets, this is the rate at which the card polls the transmit ring for new packets. The value is in units of 320 ns; a value of 0 disables polling. The default is 20 (6.4 us), and the maximum allowed value is 127. Polling is more efficient but can consume a significant amount of PCI bus bandwidth.
    This flag can be used to control the transceiver's auto polarity
    detection capability. Some Cisco Catalyst switches are known to interact badly with this feature in 10baseT mode. It defaults to 1 (enabled).

     

    AUTHOR

    This driver: Donald Becker - [email protected]

    Linux PC Card control software: David Hinds - [email protected] et al.

     

    SEE ALSO

    cardmgr(8), pcmcia(5).


     

    Index

    NAME
    SYNOPSIS
    DESCRIPTION
    PARAMETERS
    AUTHOR
    SEE ALSO


    Поиск по тексту MAN-ов: 




    Партнёры:
    PostgresPro
    Inferno Solutions
    Hosting by Hoster.ru
    Хостинг:

    Закладки на сайте
    Проследить за страницей
    Created 1996-2024 by Maxim Chirkov
    Добавить, Поддержать, Вебмастеру