The OpenNET Project / Index page

[ новости /+++ | форум | теги | ]

Интерактивная система просмотра системных руководств (man-ов)

 ТемаНаборКатегория 
 
 [Cписок руководств | Печать]

tx (4)
  • >> tx (4) ( FreeBSD man: Специальные файлы /dev/* )

  • BSD mandoc
     

    NAME

    
    
    tx
    
     - SMC 83c17x Fast Ethernet device driver
    
     
    

    SYNOPSIS

    To compile this driver into the kernel, place the following lines in your kernel configuration file:
    device miibus device tx

    Alternatively, to load the driver as a module at boot time, place the following line in loader.conf5:

    if_tx_load="YES"
    
     

    DESCRIPTION

    The driver provides support for the Ethernet adapters based on the SMC 83c17x (EPIC) chips. These are mostly SMC 9432 series cards.

    The driver supports the following media types (depending on card's capabilities):

    autoselect
    Enable autonegotiation (default).
    100baseFX
    Set 100Mbps (Fast Ethernet) fiber optic operation.
    100baseTX
    Set 100Mbps (Fast Ethernet) twisted pair operation.
    10baseT/UTP
    Set 10Mbps on 10baseT port.
    10base2/BNC
    Set 10Mbps on 10base2 port.

    The driver supports the following media options:

    full-duplex
    Set full-duplex operation.

    The driver supports oversized Ethernet packets (up to 1600 bytes). Refer to the ifconfig(8) man page on setting the interface's MTU.

    The old ``ifconfig tx0 linkN '' method of configuration is not supported.  

    VLAN (IEEE 802.1Q) support

    The driver supports the VLAN operation (using vlan(4) interfaces) without decreasing the MTU on the vlan(4) interfaces.  

    DIAGNOSTICS

    "tx%d: device timeout %d packets"
    The device stops responding. Device and driver reset follows this error.
    "tx%d: PCI fatal error occurred (%s)"
    One of following errors occurred: PCI Target Abort, PCI Master Abort, Data Parity Error or Address Parity Error. Device and driver reset follows this error.
    "tx%d: cannot allocate mbuf header/cluster"
    Cannot allocate memory for received packet. Packet thrown away.
    "tx%d: can't stop %s DMA"
    While resetting, the driver failed to stop the device correctly.

     

    SEE ALSO

    arp(4), miibus(4), netintro(4), ng_ether4, ifconfig(8)  

    BUGS

    The auto-negotiation does not work very well.


     

    Index

    NAME
    SYNOPSIS
    DESCRIPTION
    VLAN (IEEE 802.1Q) support
    DIAGNOSTICS
    SEE ALSO
    BUGS


    Поиск по тексту MAN-ов: 




    Партнёры:
    PostgresPro
    Inferno Solutions
    Hosting by Hoster.ru
    Хостинг:

    Закладки на сайте
    Проследить за страницей
    Created 1996-2024 by Maxim Chirkov
    Добавить, Поддержать, Вебмастеру