The OpenNET Project / Index page

[ новости /+++ | форум | теги | ]

Интерактивная система просмотра системных руководств (man-ов)

 ТемаНаборКатегория 
 
 [Cписок руководств | Печать]

txp (4)
  • >> txp (4) ( FreeBSD man: Специальные файлы /dev/* )

  • BSD mandoc
     

    NAME

    
    
    txp
    
     - 3Com 3XP Typhoon/Sidewinder (3CR990) Ethernet interface
    
     
    

    SYNOPSIS

    To compile this driver into the kernel, place the following line in your kernel configuration file:
    device txp

    Alternatively, to load the driver as a module at boot time, place the following line in loader.conf5:

    if_txp_load="YES"
    
     

    DESCRIPTION

    The interface provides access to the 10Mb/s and 100Mb/s Ethernet networks via the 3Com Typhoon/Sidewinder chipset.

    Basic Ethernet functions are provided as well as support for vlan(4) tag removal and insertion assistance, receive ip(4), tcp(4), and udp(4) checksum offloading, and transmit ip(4) checksum offloading. There is currently no support for transmit tcp(4) or udp(4) checksum offloading, tcp(4) segmentation, nor ipsec(4) acceleration.

    Each of the host's network addresses is specified at boot time with an SIOCSIFADDR ioctl(2). The interface employs the address resolution protocol described in arp(4) to dynamically map between Internet and Ethernet addresses on the local network.

    When a interface is brought up, by default, it will attempt to auto-negotiate the link speed and duplex mode. The speeds, in order of attempt, are: 100Mb/s Full Duplex, 100Mb/s Half Duplex, 10 Mb/s Full Duplex, and 10 Mb/s Half Duplex.

    The supports several media types, which are selected via the ifconfig(8) command. The supported media types are:

    media autoselect
    Attempt to autoselect the media type (default)
    media 100baseTX mediaopt full-duplex
    Use 100baseTX, full duplex
    media 100baseTX [mediaopt half-duplex ]
    Use 100baseTX, half duplex
    media 10baseT mediaopt full-duplex
    Use 10baseT, full duplex
    media 10baseT [mediaopt half-duplex ]
    Use 10baseT, half duplex

     

    HARDWARE

    The driver supports the following cards:

     

    SEE ALSO

    arp(4), inet(4), intro(4), ip(4), miibus(4), tcp(4), udp(4), vlan(4), ifconfig(8)  

    HISTORY

    The driver first appeared in Ox 2.9 .


     

    Index

    NAME
    SYNOPSIS
    DESCRIPTION
    HARDWARE
    SEE ALSO
    HISTORY


    Поиск по тексту MAN-ов: 




    Партнёры:
    PostgresPro
    Inferno Solutions
    Hosting by Hoster.ru
    Хостинг:

    Закладки на сайте
    Проследить за страницей
    Created 1996-2024 by Maxim Chirkov
    Добавить, Поддержать, Вебмастеру